Open main menu

Wireless communication codes

The wireless communication system uses the LoRa platform at 915 Mhz. For detailed information on what LoRa is and how it works, please refer to the LoRa research page.

The diagram for states and communication codes is on Whimsical. The prior link redirects you to the diagram.

Repository Sections

master-arduino

The master Arduino measures the battery voltage with a voltage divider circuit. For precise voltage measurements, it is recommended to use (analogRead(pin) + 0.5) * 5.0 / 1024.0 1.

backporch-arduino

anemometer

 
Anemometer data logger prototype on porch

We are using a Vortex wind sensor. One revolution per second equals 2.5 mph. Since our anemometer has a relay (a mechanical switch), it creates a switch bounce. Therefore, we need a debounce circuit.

_A bug with the current code seems to be related to saving the dateTime string. The dateTime string is saved incorrectly when there should be a trailing 0 in front of the minute reading. I believe that the current code does not include an additional 0 to save minute readings below 10.

Opportunities to improve the system

  • We are currently supplying power to the Arduinos via USB. If we used DC converters from the batteries to the Arduinos, we might save some electricity.

Useful Guides

Real Time Clock Setup for SD3231

Tutorial on arduino.com

Download DS3231 library on GitHub

Data logging on SD-card

this randomnerdtutorial.com leads you through SD-card usage with an arduino.

Wireless communication with NRF24L01

We have long-run antennas for wireless communication (NRF24L01 Tutorial).
You should solder a 10uf electrolytic capacitor between the power leads.

How to connect several SPI devices to Arduino.

Non-invasive AC Current Sensor ANSANE SCT-013-030

Outputs approximately 1 V for every 30 A.

LoRa Overview on Digikey

https://www.digikey.com/en/maker/blogs/introduction-to-lora-technology

References